Delta 6200 HD

Small Cap Grinder

SKU: Delta-6200HD-D Categories: ,
General Details

Extra Heavy Duty Cap and Rod Grinder.

The setup is very quick. Place the magnetic straight edge on the table face, then place cap or rod against the surface and tighten down. This same operation can be used on overhead cam caps.

The stone can be dressed before and / or during the grinding operation as required. The diamond dresser is mounted on the side of the actual work table.

This same operation can be used on overhead Cam caps.

  • This grinder will do caps measuring up to 3’’ in height and up to 9’’ in length.
  • The work table is 8” square. Readily grinds ends of caps after welding for better fit in block.
  • The stone will tilt for that extra fine tuning by adjusting a knob at the back of the motor.
  • The fitting of caps sideways to the block can be accomplished by installing a ½’’ key in the groove of the table and grinding the side of cap 90 degrees to the face.


  • Electrical: ¾ HP, Single Phase
  • Weight: 300 lbs

Optional cabinet is available


Information Enquiry

Information Enquiry: Delta Custom Tools – Delta 6200 HD

Your Name (required)

Your Email (required)

Your Company (required)

Your Telephone Number


Your Message

Security check: